![]() ![]() Print the cube, then use your calipers to see what width the walls of the cube are - be sure not to measure too deep - if you have elephant foot issues, it can interfere with proper measurement. Go to the "Print Settings" tab and click on "Advanced" in the left panel and verify the "Default Extrusion Width". Also make sure your filament diameter is set to 1.75, the expected diameter in an ideal situation - we want controlled, known variables for this. Go to the Filament Settings tab and make sure the Extrusion Multiplier is set to 1 for testing purposes (this is basically telling it to print at 100%, normal extrusion rate). I also recommend typical 0.20 mm layer height for this test. This sets the box to one perimeter, no top. Go to the "Print Settings" tab and check the "Spiral Vase" mode box. Choose box, then change the size from the 23.5mm default to 25mm. Start with a new, clear plate and right click and "add shape". Method 3: The most precise way to adjust for this is to create a 20 or 25mm square by adding geometry in Prusa Slicer. ![]() This will improve things a bit, but can be prone to inaccuracy due to variations in filament diameter, expansion rate of the filament, density, and other thermal properties. Method 2: Measure and adjust your filament diameter in 5-6 spots and take the average over a meter or so of filament, then input that into the filament settings. If you DO have calipers, you can do this with moderate precision. 98 first and see what kind of results you get.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |